I was following the cleaning instructions when I pushed too hard on the cap station and got it misaligned. I found a similar thread here on how to fix that, but in the process the wiper blade has come forward and I cannot figure how to reset it back into position to safely move the print head back before turning on. Any guidance is helpful!
I figured this out today so wanted to post here incase anyone else comes to this forum with this issue!
There is a little wheel on the right that you can manually move the wiper blade forward and backward. At first, it was not moving the wiper back. After I replaced and cleaned the wiper blade area, this action caused it to move slightly and I was then able to use the wheel to move it back into place.
Printer working happily now!