White tracks in GO varnish

InkjetMall Customer Support
1

Hello,

I am getting white vertical lines that look like wheel tracks, parallel to transport after Go varnish. A set of double tracks runs down an 8 x10 print at roughly 1 ¾ 3, 4¾ and 6 inches from left to right. The Go is 30000 which I’ve tested to be the minimum amount to achieve maximum density. I cant see these tracks before the varnish but I suppose its possible the varnish is making them visible.

Any suggestions would be greatly appreciated.

Thanks

Paul

2

You may want to load/print this in “front feed” mode. Your printer is marking the print with it’s front-grip star wheels.

best,
Walker

3

OK thanks,

are these star wheels affected by the platten gap setting?

Best
Paul