P600 switching from PK to MK

InkjetMall Customer Support Printer Maintenance & Cartridges
1

I knew about not switching away from PK to MK when PK is low, so I kept the printer on PK until it reset. PK now reads almost full. But now when I try to switch back to MK, which also happens to be low, I get the message about ink too low to switch to MK! I think I still have an OEM Epson MK. What is the full procedure for clearing this? Is it: 1) (with the printer on) Pull the cartridge cover plug out; 2) remove the IJM MK cartridge and put in the OEM MK cart; 3) put the cartridge cover plug back in (do I need to close the main top cover?); 4) switch from PK to MK; 5) open and pull cartridge cover plug and switch back to IJM MK (even though it’s low); 6) put plug back in and hope that the MK resets?? Do I have it right?
Dan

2

You go it right. The MK will reset when you print with it.

best,
Walker

3

So it sounds like we should use the same caution about switching blacks in either direction!
Thanks for the confirmation!
Dan

4

More so when going from MK to PK as this uses about 3x the amount of ink as going from PK to MK.

But in general, yes.

best,
Walker