Microbanding

[Robert_Kalman]

I’m getting microbanding when I apply the GO layer.

Here are the details:

> Using Jon Cone 5 w/ selenium inkset. (No banding on the initial printing).
> Nozzle check after nozzle check are “clean.”
> Microbanding is most obvious in the white margins, and seeable throughout the print when held at an angle.

Suggestions?

Thanks!

[DanaC]

It sounds like your GO channel has missing nozzles, so you have GO banding. To check your LLK/GO channel, print a nozzle check on glossy paper and view the LLK/GO channel at an angle to see the glossy nozzles. As with any ink, you want a good/full nozzle check for the best print quality.

Warmly~ Dana